Page 1 of 1

KISSLICER SUPPORT TEAM

Posted: 13 Feb 2018, 05:37
by martialgeudin
I could be wrong, but there is not much support on the forum for a software that seems to be rather well done. I have issues where I didn't had any response. Nozzle running into the bed since I use the latest KISSLICER version. And no idea where this is coming from. My machine is an ATOM 2.5EX, delta printer, dual extrusion.

Re: KISSLICER SUPPORT TEAM

Posted: 01 Mar 2018, 17:42
by cmotdibbler
Sorry I didn't see this before! There's a couple of possibilities: * it is possible you changed the "Z Offset" setting on the printer profile. The other issues are usually from a hardware problem: like the homing limit sensor slipped a little bit.