KISSLICER SUPPORT TEAM

Post Reply
martialgeudin
Posts: 3
Joined: 09 Feb 2018, 15:37

KISSLICER SUPPORT TEAM

Post by martialgeudin »

I could be wrong, but there is not much support on the forum for a software that seems to be rather well done. I have issues where I didn't had any response. Nozzle running into the bed since I use the latest KISSLICER version. And no idea where this is coming from. My machine is an ATOM 2.5EX, delta printer, dual extrusion.
cmotdibbler
Posts: 6
Joined: 10 Oct 2017, 12:42

Re: KISSLICER SUPPORT TEAM

Post by cmotdibbler »

Sorry I didn't see this before! There's a couple of possibilities: * it is possible you changed the "Z Offset" setting on the printer profile. The other issues are usually from a hardware problem: like the homing limit sensor slipped a little bit.
Post Reply