no fillament extrusion

Post Reply
shelter
Posts: 1
Joined: 03 Feb 2018, 11:35

no fillament extrusion

Post by shelter »

Hello.
Just started to use kisslicer. And faced a problem right from the start: after i load the g-code to the printer, it starts to move the nozzle, but the stepper that is supposed to push the ABS thrue the nozzle is not moving, so the nozzle is just floating in the air without printing (the stepper is OK, i tested it using CURA).

Did anyone faced the problem? Tried to search, but didn't found anything on the forum.

P.S.: sorry for my english.
Thank you.
TIQA
Posts: 3
Joined: 03 Feb 2018, 04:56

Re: no fillament extrusion

Post by TIQA »

Im haveing the same issue
TIQA
Posts: 3
Joined: 03 Feb 2018, 04:56

Re: no fillament extrusion

Post by TIQA »

i figured it out. under printed gcode settings in prefix there is a line that sets extruder in absolute or relative mode. that should be in relative M83. this fixed the issue for me :D
Post Reply