First layer override

Post Reply
TIQA
Posts: 3
Joined: 03 Feb 2018, 04:56

First layer override

Post by TIQA »

hello.

first of all, thank you developers for this fine slicer. i just switched to this from s3d, but....

there are couple of issues:

most troubling for me is that first layer is only minimum not forced. i print 99% of time with petg, and its quite a diva in regards of first layer. best first layer for me is 0.2mm, more than that and it wont stick, less than 0.2 and it develops elephant foot. if i use dynamic layer height, which i REALLY love, some times, depending on geometry, kisslicer deciedes to no go with my 1st layer setting and go with 0.3 or something else. why the F* it would do that? i thing first layer settings need to be enforced no matter what. is there a workaround?
User avatar
pjr
Posts: 692
Joined: 05 May 2015, 10:27
Location: Kamnik, Slovenia

Re: First layer override

Post by pjr »

First layer thickness is a Minimum value. If the calculated layer (using stepover) is higher then the higher value will be used.

You could add a feature request for this.

Peter
Post Reply