Insufficient prime whenever head moves without extruding
-
- Posts: 23
- Joined: 21 Nov 2014, 13:34
- Location: Utah, USA
Insufficient prime whenever head moves without extruding
Has anyone else had this sort of problem? If so, is there a solution within Kisslicer? I am at the point where I'm about ready to buy another controller board for my Cubex and switch to Slic3r to get better control, but that's a pretty drastic change (would probably also require different heads), so I REALLY don't want to go that route if there is a way to make KS work. As it is, however, I can't do anything useful that requires small features.
- plm
- Posts: 6
- Joined: 31 Dec 2017, 03:56
- Location: Moscow Russia
Re: Insufficient prime whenever head moves without extruding
I don't have lot of experience, but I've seen similar thing. On my prints if diameter of feature about 2 mm I can see similar "swiss cheese" and also strings.
Recently I've tried to print with thin layers - with bad results - guess my extruder is not OK at low mm^3/s, so I have to check it in near future.
Recently I've tried to print with thin layers - with bad results - guess my extruder is not OK at low mm^3/s, so I have to check it in near future.