Prints not centered and run off bed

Post Reply
nclindberg
Posts: 1
Joined: 26 Dec 2017, 11:11

Prints not centered and run off bed

Post by nclindberg »

I am trying to use kisslicer on my cr-10 and monoprice select mini and when I start the print it homes but then starts printing at the home corner and runs into the end stops. I have tried all the different firmware settings.
frozen.rabbit
Posts: 132
Joined: 17 Nov 2014, 09:20

Re: Prints not centered and run off bed

Post by frozen.rabbit »

not a firmware setting

go to Printer>Hardware> tab. set up bed size and bed center there. A 200x200 bed has a X 100 Y 100 center.
Post Reply