What kind of path is this?

Post Reply
DeltaCon
Posts: 9
Joined: 21 Aug 2017, 12:58

What kind of path is this?

Post by DeltaCon »

As the Subject says...
I am colorblind a bit, but I really can't find this path color in the path color legenda...
WhatPath.png
WhatPath.png (37.7 KiB) Viewed 1575 times
I am seeing some un-natural slowness in the outer perimeter, while the much faster inner perimeter prints at nice evenly speed. Also I see the fan fluctuating a bit, I think it has the same cause. And I am seeing a bit of a distortion in printquality at some of these spots. Anyone an idea about this?
zuspiel
Posts: 3
Joined: 21 Nov 2017, 13:54

Re: What kind of path is this?

Post by zuspiel »

Is there an overhang in that area? Looks like the cooling settings are kicking in.
hacker
Posts: 149
Joined: 20 Aug 2016, 18:25

Re: What kind of path is this?

Post by hacker »

I wasn't colorblind before KISSLicer, that confuses me a bit too ;-) I suspect it's unsupported area and you can check by changing display to "Material" or "Extruder" in which case unsupported tinting stays.
ähM_Key
Posts: 1
Joined: 17 Dec 2017, 07:10

Re: What kind of path is this?

Post by ähM_Key »

You probably have to increase the "Cool [mm^3/s]" value at tha "Matl" tab under "Flow Adjust", in order to maintain the speed you want.
You can also set the "Fan / Cool" settings to the same values, if you do not want to have the fan fluctuating.
Post Reply