Intro, Manual and PID parameters

Post Reply
sinned6915
Posts: 55
Joined: 28 Nov 2017, 10:06

Intro, Manual and PID parameters

Post by sinned6915 »

Greetings-

I decided to try KISSlicer after being frustrated S3D and Cura. Lots of wasted plastic on redos of prints. :( My printer is a Wanhao Di3 with Repetier on Melzi board.

Went through the setup and a couple of the wizards, and printed the test cube and was AMAZED at the quality of the print- and I have PETG in the machine to boot!

PID parameters- On one of the wizards or setups, I though there was a place to put in the PID parameters. I can not find it now and I wanted to RTFM but no luck.

I can not find the manual at any of the links in the forum... they are all 404. Did it get moved somewhere?

Am I imagining this? Is there a place to put in the PID parameters?

Thanks in advance

Dennis
User avatar
pjr
Posts: 692
Joined: 05 May 2015, 10:27
Location: Kamnik, Slovenia

Re: Intro, Manual and PID parameters

Post by pjr »

Settings Window. Printer G-code tab, Prefix , add M301 as per here: http://reprap.org/wiki/G-code#M301:_Set_PID_parameters

Peter
Post Reply