Add additional layers to top skin
-
- Posts: 21
- Joined: 05 Sep 2017, 17:08
Add additional layers to top skin
Is there a way to only add additional layers to the top of a model? I get a very thin top, but I don't want to add additional loops around the outside.
- pjr
- Posts: 692
- Joined: 05 May 2015, 10:27
- Location: Kamnik, Slovenia
Re: Add additional layers to top skin
Skin Thickness.
Only problem is that it also applies to the bottom.
Peter
Only problem is that it also applies to the bottom.
Peter
-
- Posts: 21
- Joined: 05 Sep 2017, 17:08
Re: Add additional layers to top skin
I was thinking that was it, but the tooltip says "(all surfaces: top, sides, and bottom)"pjr wrote:Skin Thickness.
Only problem is that it also applies to the bottom.
Peter
- pjr
- Posts: 692
- Joined: 05 May 2015, 10:27
- Location: Kamnik, Slovenia
Re: Add additional layers to top skin
It does not change the perimeter settings on vertical sides, only the dense infill inside the perimeters of sloping sides so that vertical thickness is at least that value.
It sets the dense fill on top and bottom.
Peter
It sets the dense fill on top and bottom.
Peter
-
- Posts: 21
- Joined: 05 Sep 2017, 17:08
Re: Add additional layers to top skin
So just to make sure I understand, if I have a 0.4mm nozzle and set the skin thickness to 1.2mm, and set loops to 2, it will still only do 2 loops for the walls?
- mhackney
- Posts: 147
- Joined: 25 Jan 2015, 10:48
- Contact: