Hello
I have last version of software.
And have a issue: printed parts are too small.
I use my preferred .stl to test size and flow - cube and cylinder. Usually fit together after small press.
But after cut in Kisslicer is big difference in dimensions.
Please look for photos.
Any ideas?
Too small parts - but .stl look good in Cura.
- mhackney
- Posts: 147
- Joined: 25 Jan 2015, 10:48
- Contact:
Re: Too small parts - but .stl look good in Cura.
How about uploading the project file and stl for this - it will help us debug. There is no reason why KISS would scale your part unless you have set the scaling explicitly.