hi guys,
I am trying to set first layer print speed to be 5mm/s and the later layers print speed to 85mm/s. This is my set up screen:
My gode shows a first layer of speed 99mm/s and later layers has a speed close to 150mm/s.
Gcode:
https://drive.google.com/open?id=0Bzke6 ... HM1SUNVajA
-
Any suggestions?
locking in print speed
- pjr
- Posts: 692
- Joined: 05 May 2015, 10:27
- Location: Kamnik, Slovenia
Re: locking in print speed
There's a few reasons for this; need to determine which one...
Can you please upload your profile Project/Save Project As, zip up the project file and attach it to a post.
Thanks.
Peter
BTW. Welcome to the forum!
Can you please upload your profile Project/Save Project As, zip up the project file and attach it to a post.
Thanks.
Peter
BTW. Welcome to the forum!
- pjr
- Posts: 692
- Joined: 05 May 2015, 10:27
- Location: Kamnik, Slovenia
Re: locking in print speed
OK, no need for the project file, loaded from G-code.
First problem is that the layer thickness is greater than the extrusion width.
You have a minimum extrusion volume of 1mm^3/sec which will override any speed settings.
Peter
EDIT: basically, you have fixed your extrusion speed by setting the Min and Max flow volumes to the same value...
First problem is that the layer thickness is greater than the extrusion width.
You have a minimum extrusion volume of 1mm^3/sec which will override any speed settings.
Peter
EDIT: basically, you have fixed your extrusion speed by setting the Min and Max flow volumes to the same value...