Top layers seem incomplete

Post Reply
Lonesomejim
Posts: 3
Joined: 27 Aug 2016, 07:29

Top layers seem incomplete

Post by Lonesomejim »

Hello community,
I Am a new user of Kisslicer. This slicer is really Great, very good job!
However in few prints I have noticed that the last top layers were like missing some steps. here is a pic to show you the problem. Any thought ?
Thanks in avance.
Attachments
WIN_20160827_14_22_20_Pro.jpg
jerrymenm
Posts: 2
Joined: 08 Sep 2016, 20:25

Re: Top layers seem incomplete

Post by jerrymenm »

Is your motor getting hot or do you hear any clicking? It might be that after some time printing it gets hot and starts skipping.
If that's not the case, you might want to check that your prime value is equal to your retraction value.

Good luck :)
dorbar
Posts: 12
Joined: 01 Sep 2016, 15:34

Re: Top layers seem incomplete

Post by dorbar »

For what I can see from the picture, I thought at first, that your skin thickness is to small (under Style Tab), but then I count the skin/wall "loops" and it should be enough. Because the Skin Thickness determine both the wall and the "roof# thickness. What I would suggest you is to play with Extrusion width, Num Loops and Skin Thickness (all in the Style Tab).

Check the User manual and the tool tips too!

D.
Post Reply