how to get Kisslicer to display model and supports

Post Reply
friarfish
Posts: 3
Joined: 06 Feb 2016, 23:29

how to get Kisslicer to display model and supports

Post by friarfish »

Hi folks,
Occasionally Kisslicer after I've done a slice will display the 3D model as well as the generated
supports. The problem is I don't know how to get it to do this all the time or what I did.
I would like to say that I've done everything to get this work but obviously I haven't.

What am I missing here?

Help appreciated.
User avatar
EddyMI3D
Posts: 81
Joined: 03 Oct 2015, 17:12

Re: how to get Kisslicer to display model and supports

Post by EddyMI3D »

Usually Kisslicer save the last settings you made.
Try to start as admin, maybe you have restrictions the place where Kisslicer runs.
User avatar
lonesock
Posts: 258
Joined: 09 Nov 2014, 18:41
Contact:

Re: how to get Kisslicer to display model and supports

Post by lonesock »

When the preview mode is "Models+Paths", if the Z slider (just to the right of the model preview) is all the way at the bottom, and if the model is already sliced, KISSlicer will display all layers' paths at the same time. I wonder if this is the behavior you were seeing? (Note: If you are in "Models_Paths" view already, and you slice the model, it will default to this view as soon as the paths are generated.)

thanks,
Jonathan
Post Reply