Min Segment Length [mm]

Post Reply
User avatar
pjr
Posts: 692
Joined: 05 May 2015, 10:27
Location: Kamnik, Slovenia

Min Segment Length [mm]

Post by pjr »

I would appreciate some input with this printer parameter...

Marlin firmware has a Min Segment Time value (on PR Marlin, set to 20 mS).

So how to properly calculate the length?

The tool tip suggests X/Y resolution (1/100) * 2 which equates to 0.02mm.

However, if I take the X/Y Jerk value (10mm/s - maybe the slowest movement?), the min segment length based on 20mS is 0.2mm.

So what value should I use for Min Segment Length?

Peter
Post Reply