drvlen with direct extruder

Post Reply
leleastro
Posts: 8
Joined: 20 Aug 2017, 13:01

drvlen with direct extruder

Post by leleastro » 26 Sep 2019, 13:00

Hi all,
should I set the drvlen parameter for titan extruder in direct mode or it's not necessary?

User avatar
pjr
Posts: 612
Joined: 05 May 2015, 10:27
Location: Kamnik, Slovenia

Re: drvlen with direct extruder

Post by pjr » 26 Sep 2019, 15:46

DrvLen is the distance between the drive gears and the tip of the nozzle, so I guess in your case it would be around 50mm.

Peter
Please note: I do not have any affiliation with KISSlicer. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss.

Post Reply