Layer Seam Location

Post Reply
Fablicator
Posts: 14
Joined: 13 Nov 2014, 13:39

Layer Seam Location

Post by Fablicator »

In the new versions of KISSlicer, is there a way to allow the seam to be on an overhanging corner?

Once overhang detection was implemented it appears to prevent seams from happening on a corner if there is any overhang at all. Is there a way to allow this again? I can't seem to find any way to disable this new behavior, or at least set some minimum threshold. It is making seam control difficult on some parts.

~Andrew
Post Reply