Double-sided adhesive

Post Reply
Nr5Alive
Posts: 5
Joined: 19 Jun 2016, 03:19

Double-sided adhesive

Post by Nr5Alive »

Double-sided adhesive:
I print with my BFB 3D Touch (Single) mainly PLA material that I Lacquer then. The pressure bed I exchanged by an aluminum plate (better flatness). Each time I use double-sided adhesive without "Raft". I so far not received a print would not hold.

KIsslicer is the first choice for my printer at the moment. Had last Simplify3D tried, but with limited success.
inventabuild
Posts: 271
Joined: 09 Nov 2014, 23:03

Re: Double-sided adhesive

Post by inventabuild »

What's the name of your double sided adhesive?
Nr5Alive
Posts: 5
Joined: 19 Jun 2016, 03:19

Re: Double-sided adhesive

Post by Nr5Alive »

Tesa (universal)
User avatar
EddyMI3D
Posts: 81
Joined: 03 Oct 2015, 17:12

Re: Double-sided adhesive

Post by EddyMI3D »

In fact, this is the same way the other tape solutions work.
The difference is, that the single sided tapes take a bit of the glue with them on the non sticky side
instead of being glues completely.
The glue stick is the same thing.

My question is, how sticky is is that sticky tape side. Can you remove the printed item with ease?

Eddy
Nr5Alive
Posts: 5
Joined: 19 Jun 2016, 03:19

Re: Double-sided adhesive

Post by Nr5Alive »

For small parts, the tape goes away well. From glue little remains. It is best to dab the remote tape afterwards the sticky part from. This makes it possible to remove almost all adhesive residue.
Post Reply