Not enough material Being Extruded after Corners

Post Reply
jaydie
Posts: 25
Joined: 24 Mar 2016, 15:24

Not enough material Being Extruded after Corners

Post by jaydie »

Need some advice how to solve this problem. It seems not enough material after every corners that why it either have too thin or there is gap .

https://youtu.be/wRTis1kOy8Y
jaydie
Posts: 25
Joined: 24 Mar 2016, 15:24

Re: Not enough material Being Extruded after Corners

Post by jaydie »

Here is the photo of the finish print with layer thickness of .25mm (ABS).
20160329_094452-1.jpg
,

I tried extruding at different temp ranged from 190 to 230 still same.
I don't have this problem when layer thickness is .5mm
I also don't have this problem with PLA.

Any idea I can try please?
User avatar
EddyMI3D
Posts: 81
Joined: 03 Oct 2015, 17:12

Re: Not enough material Being Extruded after Corners

Post by EddyMI3D »

Can you share the gcode file?
How did you create the hollow inside the cube?
I may know what's the problem, but I can tell if I had a look on the gcode...
jaydie
Posts: 25
Joined: 24 Mar 2016, 15:24

Re: Not enough material Being Extruded after Corners

Post by jaydie »

Sketchup
Kisslicer 1.5 Beta 2.22
CubeItMod 4.91
Cubex Duo Firmware 1.06
ABS fillament - I have added heat bed at 100c
Attachments
HollowCube.zip
(761.23 KiB) Downloaded 180 times
User avatar
EddyMI3D
Posts: 81
Joined: 03 Oct 2015, 17:12

Re: Not enough material Being Extruded after Corners

Post by EddyMI3D »

I thought, the corners of the inner box emerge too much into the layers so that there would be no flow.
But stl and gcode (bfb) look fine.
Maybe because of the higher speed the diagonal ways of the corner, the flow is not calculated correctly by the firmware.
jaydie
Posts: 25
Joined: 24 Mar 2016, 15:24

Re: Not enough material Being Extruded after Corners

Post by jaydie »

Many thanks for looking at it, now at lease its clear that gcode is OK. I will play with it more until I perfected this hollow cube. I always print this hollow tube whenever I have new filament to check my setting, I like it because it is quick and anyway I don't print complex parts for now.
Giovanni V.
Posts: 241
Joined: 18 Nov 2014, 09:34

Re: Not enough material Being Extruded after Corners

Post by Giovanni V. »

jaydie wrote:Many thanks for looking at it, now at lease its clear that gcode is OK. I will play with it more until I perfected this hollow cube. I always print this hollow tube whenever I have new filament to check my setting, I like it because it is quick and anyway I don't print complex parts for now.
don't use an Hollow stl, you have to use a full stl and choose infill : VASE into kisslicer
Post Reply