drvlen with direct extruder

drvlen with direct extruder

Postby leleastro » 26 Sep 2019, 13:00

Hi all,
should I set the drvlen parameter for titan extruder in direct mode or it's not necessary?
leleastro
 
Posts: 5
Joined: 20 Aug 2017, 13:01

Re: drvlen with direct extruder

Postby pjr » 26 Sep 2019, 15:46

DrvLen is the distance between the drive gears and the tip of the nozzle, so I guess in your case it would be around 50mm.

Peter
Please note: I do not have any affiliation with KISSlicer. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss.
User avatar
pjr
 
Posts: 598
Joined: 05 May 2015, 10:27
Location: Kamnik, Slovenia


Return to Tips and tricks

Who is online

Users browsing this forum: No registered users and 1 guest